![]() because of a correction for multiple testing) you can adjust this with /conf=., followed by the confidence level.īy default, for models with bootstrapping the number of bootstrap samples is 5,000. If you want to test on a different confidence level (e.g. If you want to add covariates to your model you can use /cov =., followed by one or more covariates.īy default, 95% two-sided confidence intervals are calculated. Additional syntax parameters in general (moderation or mediation) Only in front of the first parameter, y=., there is no slash.Īnd at the end of the process command (and only there) after the last parameter there has to be a period.ģ. The most important PROCESS 3 model templatesĪ full list is contained in Hayes (2017).Īll additional options start with a slash, then the parameter follows with an equal sign, and the value of the parameter, in most cases a number. You can find the most common model templates with their numbers here: So you should make sure that all variables you use differ somewhere on the first eight characters. Regarding the variable names: PROCESS allows longer variable names but internally only uses the first eight characters. Which other variables you have to include depends on the model you are testing. Process y=prejudice /x=contact /m=intergroup_anxiety /w= ideological_climate /model=7.Īll models contain y and x. Moderated Mediation (here with moderation of the a-path) Process y=prejudice /x=contact /m=intergroup_anxiety /model=4. Process y=health /x=stress /w=gender /model=1. In order to run a PROCESS model you need to include the variables and the number of the model, at least. ![]() Therefore: if you want to use the word „process“ in your comments insert a blank after each character, then it should work: I get an error message even though the SPSS editor recognizes this line as a comment (it is shown in light grey): If I write the following comment after initializing PROCESS: To do that you open the syntax file process.sps (which you get on downloading PROCESS) and run it.ĭo not use the word „process“ anywhere else in the syntax In order to run PROCESS from SPSS syntax it has to be initialized in each session you are using it.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |